my tweeters are going into protect meaning the bulb is glowing and the tweeter is distorting. im running a carver m-4120 rated at 120w a channel. my head unit is a kenwood excelon with a 5v output. i checked the output with my oscope and get 5.6v of uncliped output. my amp sensitivity maxes out at 4v so i have gains set to minimum. i trimmed the fader to allow 3.8v of output and checked the output of the amp with a 0db 1khz signal and got a unclipped output at max volume, so i should get about 120w to each side. i even have the tweeter set to -1.5db. do you think im getting too much power? i know alot of guys are biamping with alot more power. i measured the tweeters and got about 2.9 ohms but the spec. sheet says they shoud be 3.5. could this be my problem? man i hate this. maybe the old carver is under rated.