Lets see if i can get this to make sense. I recently tore apart the rig to install new cables. Afterr I got it back together my right channel is not working. Also my BFD is only showing the left channel working.
So here is what I did.
Checked my setup on the Rotel (i think it is right)
Swapped cables to see if i have a bad one (doesn't appear to be the case)
One curious note, when I undo the left channel IC I lose all sound, ok, because the right channel isn't working. But when I swap channels, for example when I run from rotel left to amp right it still plays on the left speaker and the bfd still shows only left channel.
I did end up with an extra cable or two when I got it all put back together :o but I think I have all my hookups correct.
ps I also installed my new cdp at the same time.