Installing second amp signal cable

[jhornsbee1]

I just got a second amp, and i have everything hooked up except for the signal cable. Is the a way to run it from the allready existing signal cable, or do i need to take off the head unit again and input it to another pre-out... please help, want to be able to use my new system.

[GLN305]

Give us some details on your system:

1. What amps are you using?
2. What are the amps being used for (subwoofer, front speakers, rear speakers, etc)?
3.What head unit are you using?

Make sure and tell us all the equipment you are using so that we can give you a clear and directed answer.

[jhornsbee1]

The amps are for my subs, i have two kenwood kac-9103d 1800watt amps and two 1500 watt 12" ALPINE SWR-1242D. I have the amps hooked up allready except for the signal cable on the second amp. The inputs on the amps are rca inputs. how would i jump the signal cable from the first amp to the second?

[chunk69]

hey gt wt i meant from other page

[GLN305]

OK, I just looked on Crutchfield at your amp and it apparently has Line outputs. You can run an RCA cable from the line output of the amp you have the signal going to now into the other amp's line input.

[chunk69]

just asked that on dif page
another words using amp as junction rca leads going through amp

[GLN305]

just asked that on dif page
another words using amp as junction rca leads going through amp

Yup, basically feeding the signal into and through the first amp and out to the second.