Hey, this is a repost from a different(wrong) section, i apologize if anyone is reading this twice.
Hey all, my first post here, so complete noob as it stands.
I've just purchased and built a box for two MM2124 SVC subs. I'm going to use my current a800t monoblock audiobahn amp(yeah i know it's not great quality but i can't afford a new one atm) to power them.
I'm wiring them in parallel which satisfies my power/resistence requirements..
My only problem is actually implementing it. I was initially going to just install a terminal in the side of the box and have two wires running off the positive and negative terminals two each of the speakers, but i've since heard there's a fair bit of signal loss in using a terminal.
So my question in short is how do i wire my subs in parallel with minimal signal loss where i split my positive and negative wires? If that makes sense..
Any help is much appreciated. Cheers.. :)