What Amplifier Powers Your SR Sub?

[BradimusMaximus]

I am thinking of getting an amplifier with a little more ompf. I am curious as to what everyone else is using to power their SR subwoofer. I have a single SR124 powered by a Kenwood Excelon KAC-X520 that provides 500RMS bridged at 4 ohms bridged mono.

[eloplayspolo]

pdx 1.1000 is a good pick

[black magic]

Right now I'm using a Polk c500.1 for each of my SR124 dvc subs at a 2 ohm load for 500 watts each. Next summer I will (hopefully) be upgrading to two of Polks new amps... the PA1200.1

[Bruizer]

I've got 2 Polk SR124-DVCs wired in at 1ohm with a Kicker SX1250.1 (birthsheet rated 1410watts).

[Canuker]

I have a SR124dvc powered by a older PPI4100, bridged to each coil it pushes around 400-450 for about 900 watts. Truthfully I was thinking about going bigger still as I find it a little underpowered when compared to my SR6500's which are ran by a PPI 2100(2*100).

I was thinking about moving the 4100 to the fronts and having 100 watts going to each driver and getting a PPI 2350 which does about 1350 watts when bridged. Just don't know how I would wire it....but we shall see. I've only had it all in the car for a week or so.

[MacLeod]

Polk Audio PA1200.1 running at 2 ohms. Plenty of oomph. Ive got the sub channel turned down 9 db just to blend in!

[BradimusMaximus]

My Pioneer head unit has an auto calibration function to set the distance, and gain levels for each of the speakers for my listening position. It does an auto-eq set up as well which does a pretty good job. It sets my single 12 down about to what it refers to as -10. I prefer a little more bass than a totally flat setting so I put it at around -7. I find with some bass heavy music the amp I have will simply run out of steam and clip. I was thinking of getting a second sub and a new amp or maybe just a bit more amplifier power. The amp I have is probably 5 years old and well used. I doubt its making anywhere near its power specs anymore.

You guys all have some nice stuff!

[killerb]

i have a massive audio p1500 powering 2 12" sr's with 1500 watts @ 1 ohm.

[Kinetic]

Alpine PDX 1.1000, but running 750 RMS aprox

nice clean power

[black magic]

Kinetic, have you gotten around to installing your SR components? How do you like them?

[Kinetic]

Kinetic, have you gotten around to installing your SR components? How do you like them?

i havent recived the speaker cables from Knukonceptz (they where supposed to be here since last week)

so i havent try them properly, as soon as i try them i will let you know...

i have the interior of car in pieces, ready to be wired up.
i buy these:
http://www.knukonceptz.com/productDe...ID=KAR16SS-100

to connect the drivers to the crossover

[black magic]

i havent recived the speaker cables from Knukonceptz (they where supposed to be here since last week)

so i havent try them properly, as soon as i try them i will let you know...

i have the interior of car in pieces, ready to be wired up.
i buy these:
http://www.knukonceptz.com/productDe...ID=KAR16SS-100

to connect the drivers to the crossover

Cool. I hope everything goes well.