Hey, I got a few more questions about this iso-stuff.
1.)I read someewhere in a Iso-push/pull setup, you can almot triple the RMS power of the subs with out blowing them, and I was wondering if this was possible with the DX-12s. I had 2 15" RF series 1's in a Iso-push/pull with about 700 watts going to them, each wooker takes 150 wrms.
2.)Would I have to have a ported chamber, or could I go without that half of the box?
3.) Using 4 woofers, how could I achieve a 2ohm load? I have heard mixed responsese about this...
I am planning on using a RF bd1500.1 to power 4 of these woofers, and from what I am reading they throw out about 1700watts rms at 2 ohms, and that is where I plan on running it, and with 4 woofers, the RMS power is a total of 1600, plus after they get broken in, they can take a little more, and in an Iso setup, can take a lot more, then, I think I would have plenty of power for these bad boyz.