OK so i ordered a set of 10" DVC momo subs....but they had sent me the new DB subs. Called polk and they told me the Momo line is being replaced so those subs were the closest matching to the ones i ordered.
After getting refunded the difference. I now have a PA600.1 and 2 DB subs.
My problem is that the DB subs run at 250W RMS....and the amp i will be using runs at 600W...because i am bridging down to 1 ohm.
Is this too much for the subs?. Any suggestions on what I should do?
this is the last part of my audio system i need to finish...well besides putting the radio in.