ATTN - CSi4 & CSiA4 owners

[curved]

How deep is these? On the site, it's roughly 9 inches. Is that with the flared port or without.....my mantle is 8 inches in depth. I won't mind if it sticks out less than an inch, but anymore would be unsightly.

[leroyjr1]

The csi a4 doesn't have the power port on back. I just sold mine so I can't measure but you should be ok.

[curved]

I'm going to downgrade to either one.....the CSi5 and CS400 don't come anywhere close to fitting - they are both HUGE!!!

[leroyjr1]

You can get the csi 3 on ebay for about $125 shipped

This is your best bet. Jump on it. It's a perfect match for your RTI 8's

http://cgi.ebay.com/New-Polk-Audio-C...QQcmdZViewItem

[VSchneider]

I think you meant "CSi3 and A4". I can measure my unused CSi3 for you. Will you have it on the flat side or angled up?

[Erik Tracy]

I have the CSi3 and no it does not have the rear port.

The specs on the Polk Site are accurate for its depth.

[Tracy]

I have the CS1 A4 and it is exactly 8 inches deep and just shy of 7 inches tall (without rubber feet) on the face. You may wanna give it another half inch deep for speaker wire.

[curved]

I think you meant "CSi3 and A4". I can measure my unused CSi3 for you. Will you have it on the flat side or angled up?

That's what I meant:p

It will sit on my mantle with the slanted part on the top. I will probably even have to tip it down because the mantle is about 4 feet off the ground.