YAY!!!!!! im not 100% broke anymore!!!!!!! but seriously, thank god
Anyways so, i finally have the money to get some build materials to finish my install... only a year and a half, i know thats nothing compared to cody :)
so ive had plenty of time to think about how i want to set up my install and i came to the conclusion that i want to put my amps in my spare tire well (i dont use the spare). So pretty much i am left with a few questions and looking for some suggestions.
Is heat going to be a problem?
Has anyone here done this before? either on ur setup or someone elses?
i saw this interesting DIY post.... but i dont think i need something so complex...
i was thinking something along the lines of.....
so u have 1 piece of MDF on the bottom that is fasted onto the spare tire well floor, and then u have 2 pieces of MDF installed into that at about a 30-45 Degree angle, this piece is = to the width of the floor, and at the end, has a support piece that goes straight down and is fasted into the wood again, this would be done twice. you are now left with 2 angled bases for the amps to rest on. I was thinking that i could cut out a few vent holes under where the amps would go for some ventilation, im also thinking that i could make my wires very clean under here.
sorry about the diagram. im on a laptop and my photoshop program needs to be reinstalled.... so paint was my friend and i had to use the synaptic touch device to do it.