I have just run into a new problem(that I thought I had figured out but I guess not). I have a hatchback and am mounting my apms (fan cooled) under a piece of 1/2" arcrylic so I don't set anything on top of them or damage them. I am also putting in two MOMO MM10's. I thought that I had measured correctly (enter Murphy's law) and thought that I had the clearence to just put them on top of the arcrylic. Think again. Now I need to know any suggestions for mounting the MM10's at either an angle or on thier back. I was thinking if I mounted them to a piece of acrylic I could then somehow mount that arcrylic to the sheet that will be protecting the amps and caps. Please let me know if you guys have any ideas on how to angle mount an MM10. Remember that the factory mounting brackets are on the bottom of the box and I would like to use these so I don't screw up my warrenty.