Pulled out the hu and checked to ensure no connection was loose. All looks ok.Check your RCA's from the Hu, Rear = Mids & Fronts= tweets I believe
Did that in NW mode but still no mids. Then I set the switch back to std mode and reset. In std mode......no prob all 5 drivers (comps+sub) played fine. Went back to nw mode and again no mids.If you didn't reset your deck you must do so. Otherwise Network Mode won't work correctly
Tweets set at -8 gain till we figure out whats wrong.Just make sure you turn the gain down for the tweeter and don't crank it up until you are 100% positive you have everything set correctly
Since I normally adjust everything for l/r i leave everything the way you mention, where u can tune seperately for l/r.One thing it won't tell you and it will allow you to adjust each speaker separately instead of just FR & FL. Go to the audio adjustment screens and scroll through until you see "NW 2" or "NW 3" on the upper part of the screen. Push in on the directional button on the remote or Hu in until it allows you to adjust everything separately. Never go back to the other option because settings don't carry over to the other.
yes I do, thats the next step...........Do you have a manual for this? If so, read through the entire network mode section.