Low cost good amp for db5251's

[xj4094dg]

Hello Car Audio Forum Gurus.

I haven't done any Car Audio in years and don't know anything anymore. I bought a pair of db5251's and need a low cost amp.

Something good, but no huge budget ($100.00 or less?). I got a new pair of db5251's from Polk for $79.00 (using 100 Polk bucks).

Suggestions welcome.

Thanks in advance.

[cadenceclipse]

no, not a huge budget, good luck. i think walmart sells amps for $100. who'd want that though. crutchfield actually has 3 amps under 100 rite now. i'd act. if i had 2 choose i'd say RF. but can't beat cadence outlet. cadencesound.com. proly get a 4channel for that price. i want some polk buks

[greg2350]

I know this is 60 more than your budget but they would make those db's sound so good.

http://www.sonicelectronix.com/item_...o+PA200.4.html

[xj4094dg]

Thanks greg2350 and cadenceclipse.

Again, I don't know S about car audio, many $ have been spent on the home system, but I don't spend a lot of time in the Jag so I don't want to spend a huge amount there.

I'm checking out all your suggestions though and appreciate your input. I love this forum....

Do either of you know anything about this alpine amp: Alpine MRP-F240 ?

Thanks again.

BTW, polk sent me an email to take part in a survey one day and gave me the POLK BUCKS for my time.

[cadenceclipse]

yeah, its an alpine, so can't b that bad.

polk amps on sale at crutchfield now. stil say cadence..

word, was that survey for home audio?

[xj4094dg]

yeah, its an alpine, so can't b that bad.

polk amps on sale at crutchfield now. stil say cadence..

word, was that survey for home audio?

The survey was regarding the new look of the website. I told them it looked like they were selling lots of outdoor and HT in a box at first glance. I thought the site examples they showed me were kinda cheesy.

[cadenceclipse]

and they gave u 100 buks?? sweet what u want 2 know about amp? think u want 2 know about a diff. amp..

[xj4094dg]

OK. I found this amp: Alpine MRP-F240 V-Power Car Amplifier. 64.99.

Specs:

Power Output: RMS Continuous Power (at 14.4V, 20 Hz to
20kHz)
Per channel into 4 ohms (0.08% THD) ... MRP-F240: 40Wx4
MRP-T220: 50Wx2
Per channel into 2 ohms (0.3% THD) ..... MRP-F240: 50Wx4
MRP-T220: 70Wx2
Bridged into 4 ohms (0.3% THD) ......... MRP-F240: 100Wx2
MRP-T220: 140Wx1
Total MAX Power .......................................... MRP-F240: 360W
MRP-T220: 250W
Frequency Response ................... 10 Hz to 50 kHz (+0, –1 dB)
Signal-to-Noise Ratio
(referenced to rated power) ........................................ 100 dBA
Slew factor .................................................. ...... Greater than 5
Input Sensitivity (for rated power
output) ........................ 200mV to 4.0V (1.0V at center detent)
Input Impedance .................................................. . 10k ohms<
Speaker Impedance ............................... 4 or 2 ohms (Stereo),
4 ohms (Bridged)
Active Dividing Network Frequency and
Slope .................................................. 80 Hz, 18 dB per octave
Bass EQ ........................ MRP-F240: 50Hz, 0 to +12 dB (CH3/4)
MRP-T220: 50Hz, 0 to +12 dB (CH1/2)
Power Requirement .................. 11 – 16V DC Negative Ground
Dimensions (W x H x D)
MRP-F240 ................................ 266mm x 60mm x 242mm
(10-7/16" x 2-3/8" x 9-1/2")
MRP-T220 ................................ 206mm x 60mm x 242mm
(8-1/8" x 2-3/8" x 9-1/2")


What do you think? Will this work? Again, its within budget.

Thanks.