RM6750 Subwoofer on Yamaha RX-V465 Receiver

FuzzyReets · 11-07-2009, 01:52 PM

Hi folks. I'm just a newb getting into all of this home theater stuff a little and had some questions about my sub settings, mainly, what is all this stuff and what do I set it to? I have the Polk RM6750 sub and on the back there are settings for the following:

- Phase
- Low Pass
- Volume

I connect these to my receiver using a standard RCA cable to the sub out on the receiver and I'm not sure what the appropriate settings are for the sub to work with the receiver properly.

Then on the receiver I have the following related to the sub:

Crossover Setting
Phase - Norm or Rev

I'm not sure what to set any of this stuff. Help would be greatly appreciated! Thanks!

zarrdoss · Today, 10:22 PM

On sub: Phase, I usually set to normal or zero you can play with it and see what you prefer. Low pass= the lowest frequency you want to go through your sub usually cut off at 60 or so but again play with it and see what you like. and Volume= no brainier.

On receiver Phase normal or reverse leave on normal as this does the same on your sub and you should only mess with one of them.

11-07-2009, 01:52 PM	#1
FuzzyReets Polkie Member Sales Rating: (0) Join Date: Nov 2009 Posts: 2	RM6750 Subwoofer on Yamaha RX-V465 Receiver Hi folks. I'm just a newb getting into all of this home theater stuff a little and had some questions about my sub settings, mainly, what is all this stuff and what do I set it to? I have the Polk RM6750 sub and on the back there are settings for the following: - Phase - Low Pass - Volume I connect these to my receiver using a standard RCA cable to the sub out on the receiver and I'm not sure what the appropriate settings are for the sub to work with the receiver properly. Then on the receiver I have the following related to the sub: Crossover Setting Phase - Norm or Rev I'm not sure what to set any of this stuff. Help would be greatly appreciated! Thanks!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RM6750's & Yamaha RX-V465 - Sub Cable or Speaker Wire	chris83	Subwoofer Hookup & Bass Management	10	06-05-2009 10:33 AM
opinions on Yamaha RX-V465	bevans	Electronics	14	03-12-2009 02:51 AM
Need Help RM6750 Subwoofer	gijoe	Troubleshooting	3	06-26-2008 08:47 PM
RM6750 Subwoofer Problem	gijoe	Troubleshooting	0	06-24-2008 03:31 PM
Subwoofer hookup RM6750	melissaF	Subwoofer Hookup & Bass Management	2	10-28-2007 07:16 PM

Today, 10:22 PM	#2
zarrdoss Polkhead Member Sales Rating: (1) Join Date: Jan 2009 Location: Northern CO. Posts: 1,293	On sub: Phase, I usually set to normal or zero you can play with it and see what you prefer. Low pass= the lowest frequency you want to go through your sub usually cut off at 60 or so but again play with it and see what you like. and Volume= no brainier. On receiver Phase normal or reverse leave on normal as this does the same on your sub and you should only mess with one of them.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)