Free Shipping on All U.S. Orders!

PA880

SKU 1165
High performance monoblock mobile audio amplifier
Pre-order: This product is expected to begin shipping on . Your credit card will not be charged until the item ships.
Color: Please select a color

Pure performance


The PA880 is a single-channel class A/B amplifier with built-in fully variable low-pass crossover. The PA880 monoblock is equipped with optional remote bass EQ control and is capable of one-channel operation with a maximum power of 800 Watts into 2 ohms.

PA880 Features:

  • Mono-block amplifier for subwoofer use.
  • 300 Watts x 1 (4 ohm), 500 Watts x 1 (2 ohm).
  • CEA-2006 compliant specifications for true, accurate power ratings.
  • 800 Watts x 1 (2 ohm) dynamic power.
  • 2 ohm stable design can drive even the most demanding subwoofers.
  • Power and ground terminals accept bare wire up to 4 AWG. Terminals use standard #2 Phillips head screwdriver-no more hex wrenches to lose or strip!
  • High-speed MOSFET switching power supply and high current bipolar output transistors pump maximum voltage and high current to your speakers or subwoofers.
  • Double layer fiberglass epoxy printed circuit boards for more rigidity, less shrinkage and a smaller overall amp footprint.
  • 6-way Smart System Protection (SSP) circuits.
  • Switchable 3-position bass boost (0dB, 6dB, 12dB) for extra bass thump.
  • Switchable 180° phase inversion for easy sub to main integration.
  • RCA outputs for easy daisy chaining of other amplifiers.
  • Mounting hardware with rubber isolation grommets and extra fuses included.
  • Status LEDs give instant information on amplifier operation.
Audio
Amplifier Power Specs Dynamic Power at 14.4V Watts per channel NOT bridged @ 1 kHz - 2 ohms 800 watts
Amplifier Power Specs Dynamic Power at 14.4V Watts per channel NOT bridged @ 1 kHz - 4 ohms 500 watts
Amplifier Power Specs RMS Power at 14.4V Watts per channel NOT bridged @ 1 kHz - 2 ohms 500 watts
Amplifier Power Specs RMS Power at 14.4V Watts per channel NOT bridged @ 1 kHz - 4 ohms 300 watts
Amplifier Specs - 12V & Ground Cable Gauge 4AWG
Amplifier Specs - Bass Boost Characteristics 3-position(0,6,12dB) Hz
Amplifier Specs - Channel Notes Class AB MOSFET
Amplifier Specs - Channels 1
Amplifier Specs - Total Dynamic Power 800 watts
Dimensions - Product Weight (each) 7.80 pounds
Dimensions With Panels - Depth 8 1/8 (20.64cm) "
Dimensions With Panels - Height 2 (5.08cm) "
Dimensions With Panels - Width 13 1/4 (33.66cm) "
Electrical - Distortion at Rated Power 0.90%
Electrical - Effective Damping Factor >150
Electrical - Max Sensitivity 200mV-5 dB
Electrical - Minimum Impedance Bridged 4 ohms
Electrical - Minimum Impedance Not Bridged 2 ohms
Electrical - Signal-to-noise (Referenced to rated power) 80 dBA
Electrical - Total Frequency Response 10Hz-30kHz
Electrical Low Pass Filter - Filter Frequency 50Hz-500Hz
Electrical Low Pass Filter - Filter Slope 12dB/oct
Shipping - Total Shipping Weight 9.80 pounds
Recommended For You